Biomechanical evaluation of two alternative techniques to the Goel-Harms technique for atlantoaxial fixation: C1 lateral mass–C2 bicortical translaminar screw fixation and C1 lateral mass–C2/3 transarticular screw fixation

View More View Less
  • 1 Department of Neurosurgery, Chinese PLA General Hospital, Beijing; and
  • 2 Key Laboratory of Modern Measurement and Control Technology, Ministry of Education, Beijing Information Science and Technology University, Beijing, China

OBJECTIVE

The authors conducted a study to investigate the biomechanical feasibility and stability of C1 lateral mass–C2 bicortical translaminar screw (C1LM-C2TL) fixation, C1 lateral mass–C2/3 transarticular screw (C1LM-C2/3TA) fixation, and C1LM-C2/3TA fixation with transverse cross-links (C1LM-C2/3TACL) as alternative techniques to the Goel-Harms technique (C1 lateral mass–C2 pedicle screw [C1LM-C2PS] fixation) for atlantoaxial fixation.

METHODS

Eight human cadaveric cervical spines (occiput–C7) were tested using an industrial robot. Pure moments that were a maximum of 1.5 Nm were applied in flexion-extension (FE), lateral bending (LB), and axial rotation (AR). The specimens were first tested in the intact state and followed by destabilization (a type II odontoid fracture) and fixation as follows: C1LM-C2PS, C1LM-C2TL, C1LM-C2/3TA, and C1LM-C2/3TACL. For each condition, the authors evaluated the range of motion and neutral zone across C1 and C2 in all directions.

RESULTS

Compared with the intact spine, each instrumented spine significantly increased in stability at the C1–2 segment. C1LM-C2TL fixation demonstrated similar stability in FE and LB and greater stability in AR than C1LM-C2PS fixation. C1LM-C2/3TA fixation was equivalent in LB and superior in FE to those of C1LM-C2PS and C1LM-C2TL fixation. During AR, the C1LM-C2/3TA–instrumented spine failed to maintain segmental stability. After adding a cross-link, the rotational stability was significantly increased in the C1LM-C2/3TACL–instrumented spine compared with the C1LM-C2/3TA–instrumented spine. Although inferior to C1LM-C2TL fixation, the C1LM-C2/3TACL–instrumented spine showed equivalent rotational stability to the C1LM-C2PS–instrumented spine.

CONCLUSIONS

On the basis of our biomechanical study, C1LM-C2TL and C1LM-C2/3TACL fixation resulted in satisfactory atlantoaxial stabilization compared with C1LM-C2PS. Therefore, the authors believe that the C1LM-C2TL and C1LM-C2/3TACL fixation may serve as alternative procedures when the Goel-Harms technique (C1LM-C2PS) is not feasible due to anatomical constraints.

ABBREVIATIONS AR = axial rotation; C1LM-C2PS = C1 lateral mass–C2 pedicle screw; C1LM-C2TL = C1 lateral mass–C2 bicortical translaminar screw; C1LM-C2/3TA = C1 lateral mass–C2/3 transarticular screw; C1LM-C2/3TACL = C1LM-C2/3TA fixation with transverse cross-links; FE = flexion-extension; LB = lateral bending; NZ = neutral zone; ROM = range of motion.

Contributor Notes

Correspondence Yi-Heng Yin: Chinese PLA General Hospital, Beijing, China. yihengyin@aliyun.com.

INCLUDE WHEN CITING Published online January 17, 2020; DOI: 10.3171/2019.11.SPINE191178.

Y.Q.D. and T.L. contributed equally to this work.

Disclosures The authors report no conflict of interest concerning the materials or methods used in this study or the findings specified in this paper.

  • 1

    Anderst WJ, Donaldson WF III, Lee JY, Kang JD: Cervical motion segment contributions to head motion during flexion, lateral bending, and axial rotation. Spine J 15:25382543, 2015

    • Search Google Scholar
    • Export Citation
  • 2

    Chandra PS, Kumar A, Chauhan A, Ansari A, Mishra NK, Sharma BS: Distraction, compression, and extension reduction of basilar invagination and atlantoaxial dislocation: a novel pilot technique. Neurosurgery 72:10401053, 2013

    • Search Google Scholar
    • Export Citation
  • 3

    Claybrooks R, Kayanja M, Milks R, Benzel E: Atlantoaxial fusion: a biomechanical analysis of two C1-C2 fusion techniques. Spine J 7:682688, 2007

    • Search Google Scholar
    • Export Citation
  • 4

    Dmitriev AE, Lehman RA Jr, Helgeson MD, Sasso RC, Kuhns C, Riew DK: Acute and long-term stability of atlantoaxial fixation methods: a biomechanical comparison of pars, pedicle, and intralaminar fixation in an intact and odontoid fracture model. Spine (Phila Pa 1976) 34:365370, 2009

    • Search Google Scholar
    • Export Citation
  • 5

    Dorward IG, Wright NM: Seven years of experience with C2 translaminar screw fixation: clinical series and review of the literature. Neurosurgery 68:14911499, 2011

    • Search Google Scholar
    • Export Citation
  • 6

    Duan S, Lv S, Ye F, Lin Q: Imaging anatomy and variation of vertebral artery and bone structure at craniocervical junction. Eur Spine J 18:11021108, 2009

    • Search Google Scholar
    • Export Citation
  • 7

    Goel A: Caudally directed inferior facetal and transfacetal screws for C1-C2 and C1-2-3 fixation. World Neurosurg 100:236243, 2017

  • 8

    Goel A, Achawal S: The surgical treatment of Chiari malformation association with atlantoaxial dislocation. Br J Neurosurg 9:6772, 1995

    • Search Google Scholar
    • Export Citation
  • 9

    Goel A, Laheri V: Plate and screw fixation for atlanto-axial subluxation. Acta Neurochir (Wien) 129:4753, 1994

  • 10

    Harms J, Melcher RP: Posterior C1-C2 fusion with polyaxial screw and rod fixation. Spine (Phila Pa 1976) 26:24672471, 2001

  • 11

    Hart R, Hettwer W, Liu Q, Prem S: Mechanical stiffness of segmental versus nonsegmental pedicle screw constructs: the effect of cross-links. Spine (Phila Pa 1976) 31:E35E38, 2006

    • Search Google Scholar
    • Export Citation
  • 12

    Huang DG, Hao DJ, He BR, Wu QN, Liu TJ, Wang XD, : Posterior atlantoaxial fixation: a review of all techniques. Spine J 15:22712281, 2015

    • Search Google Scholar
    • Export Citation
  • 13

    Ishii T, Mukai Y, Hosono N, Sakaura H, Fujii R, Nakajima Y, : Kinematics of the cervical spine in lateral bending: in vivo three-dimensional analysis. Spine (Phila Pa 1976) 31:155160, 2006

    • Search Google Scholar
    • Export Citation
  • 14

    Ishii T, Mukai Y, Hosono N, Sakaura H, Fujii R, Nakajima Y, : Kinematics of the subaxial cervical spine in rotation in vivo three-dimensional analysis. Spine (Phila Pa 1976) 29:28262831, 2004

    • Search Google Scholar
    • Export Citation
  • 15

    Jea A, Sheth RN, Vanni S, Green BA, Levi AD: Modification of Wright’s technique for placement of bilateral crossing C2 translaminar screws: technical note. Spine J 8:656660, 2008

    • Search Google Scholar
    • Export Citation
  • 16

    Lehman RA Jr, Dmitriev AE, Wilson KW: Biomechanical analysis of the C2 intralaminar fixation technique using a cross-link and offset connector for an unstable atlantoaxial joint. Spine J 12:151156, 2012

    • Search Google Scholar
    • Export Citation
  • 17

    Liu S, Song Z, Liu L, Yin X, Hu X, Yang M, : Biomechanical evaluation of C1 lateral mass and C2 translaminar bicortical screws in atlantoaxial fixation: an in vitro human cadaveric study. Spine J 18:674681, 2018

    • Search Google Scholar
    • Export Citation
  • 18

    Lu Y, Lee YP, Bhatia NN, Lee TQ: Biomechanical comparison of C1 lateral mass–C2 short pedicle screw–C3 lateral mass screw-rod construct versus Goel-Harms fixation for atlantoaxial instability. Spine (Phila Pa 1976) 44:E393E399, 2019

    • Search Google Scholar
    • Export Citation
  • 19

    Moon BJ, Choi KH, Shin DA, Yi S, Kim KN, Yoon DH, : Anatomical variations of vertebral artery and C2 isthmus in atlanto-axial fusion: consecutive surgical 100 cases. J Clin Neurosci 53:147152, 2018

    • Search Google Scholar
    • Export Citation
  • 20

    Panjabi M, Dvorak J, Duranceau J, Yamamoto I, Gerber M, Rauschning W, : Three-dimensional movements of the upper cervical spine. Spine (Phila Pa 1976) 13:726730, 1988

    • Search Google Scholar
    • Export Citation
  • 21

    Senturk S, Akyoldas G, Yaman O, Ozer AF: A new technique for the surgical treatment of atlantoaxial instability: C1 lateral mass and C2-3 transfacet screwing. Turk Neurosurg [epub ahead of print], 2017

    • Search Google Scholar
    • Export Citation
  • 22

    Sim HB, Lee JW, Park JT, Mindea SA, Lim J, Park J: Biomechanical evaluations of various C1-C2 posterior fixation techniques. Spine (Phila Pa 1976) 36:E401E407, 2011

    • Search Google Scholar
    • Export Citation
  • 23

    Su BW, Shimer AL, Chinthakunta S, Salloum K, Ames CP, Vaccaro AR, : Comparison of fatigue strength of C2 pedicle screws, C2 pars screws, and a hybrid construct in C1-C2 fixation. Spine (Phila Pa 1976) 39:E12E19, 2014

    • Search Google Scholar
    • Export Citation
  • 24

    Wright NM: Posterior C2 fixation using bilateral, crossing C2 laminar screws: case series and technical note. J Spinal Disord Tech 17:158162, 2004

    • Search Google Scholar
    • Export Citation
  • 25

    Yin YH, Tong HY, Qiao GY, Yu XG: Posterior reduction of fixed atlantoaxial dislocation and basilar invagination by atlantoaxial facet joint release and fixation: a modified technique with 174 cases. Neurosurgery 78:391400, 2016

    • Search Google Scholar
    • Export Citation
  • 26

    Zong R, Li T, Lu L, Qiao G, Yu X: Posterior C2 fixation using trans-C2 inferior articular process screws: a case series and technical note. World Neurosurg 121:e70e76, 2019

    • Search Google Scholar
    • Export Citation

Metrics

All Time Past Year Past 30 Days
Abstract Views 223 223 223
Full Text Views 51 51 51
PDF Downloads 100 100 100
EPUB Downloads 0 0 0