Browse

You are looking at 1 - 2 of 2 items for

  • By Author: Crawford, Neil R. x
  • By Author: Theodore, Nicholas x
  • By Author: Horn, Eric M. x
  • By Author: Sonntag, Volker K. H. x
Clear All
Restricted access

Eric M. Horn, Phillip M. Reyes, Seungwon Baek, Mehmet Senoglu, Nicholas Theodore, Volker K. H. Sonntag and Neil R. Crawford

Object

The small diameter of the pedicle can make C-7 pedicle screw insertion dangerous. Although transfacet screws have been studied biomechanically when used in pinning joints, they have not been well studied when used as part of a C7–T1 screw/rod construct. The authors therefore compared C7–T1 fixation using a C-7 transfacet screw/T-1 pedicle screw construct with a construct composed of pedicle screws at both levels.

Methods

Each rigid posterior screw/rod construct was placed in 7 human cadaveric C6–T2 specimens (14 total). Specimens were tested in normal condition, after 2-column instability, and once fixated. Nondestructive, nonconstraining pure moments (maximum 1.5 Nm) were applied to induce flexion, extension, lateral bending, and axial rotation while recording 3D motion optoelectronically. The entire construct was then loaded to failure by dorsal linear force.

Results

There was no significant difference in angular range of motion between the 2 instrumented groups during any loading mode (p > 0.11, nonpaired t-tests). Both constructs reduced motion to < 2° in any direction and allowed significantly less motion than in the normal condition. The C-7 facet screw/T-1 pedicle screw construct allowed a small but significantly greater lax zone than the pedicle screw/rod construct during lateral bending, and it failed under significantly less load than the pedicle screw/rod construct (p < 0.001).

Conclusions

When C-7 transfacet screws are connected to T-1 pedicle screws, they provide equivalent stability of constructs formed by pedicle screws at both levels. Although less resistant to failure, the transfacet screw construct should be a viable alternative in patients with healthy bone.

Restricted access

Eric M. Horn, Nicholas Theodore, Neil R. Crawford, Nicholas C. Bambakidis and Volker K. H. Sonntag

Object

Lateral mass screws are traditionally used to fixate the subaxial cervical spine, while pedicle screws are used in the thoracic spine. Lateral mass fixation at C-7 is challenging due to thin facets, and placing pedicle screws is difficult due to the narrow pedicles. The authors describe their clinical experience with a novel technique for transfacet screw placement for fixation at C-7.

Methods

A retrospective chart review was undertaken in all patients who underwent transfacet screw placement at C-7. The technique of screw insertion was the same for each patient. Polyaxial screws between 8- and 10-mm-long were used in each case and placed through the facet from a perpendicular orientation. Postoperative radiography and clinical follow-up were analyzed for aberrant screw placement or construct failure.

Results

Ten patients underwent C-7 transfacet screw placement between June 2006 and March 2007. In all but 1 patient screws were placed bilaterally, and the construct lengths ranged from C-3 to T-5. One patient with a unilateral screw had a prior facet fracture that precluded bilateral screw placement. There were no intraoperative complications or screw failures in these patients. After an average of 6 months of follow-up there were no hardware failures, and all patients showed excellent alignment.

Conclusions

The authors present the first clinical demonstration of a novel technique of posterior transfacet screw placement at C-7. These results provide evidence that this technique is safe to perform and adds stability to cervicothoracic fixation.